HIGH FLYING Car Led Side Mirrors Sequential Dynamic Turn Signal Lights Indicator 2pcs/Pair for Toyota Tacoma 2016-2023, RAV4 2019-2025, Highlander 2020-2025 (Type B)

Installed on 2024 Rav4 xle hybrid. Watch utube Morozov automotive video a few times. Took around 10 mins per mirror to remove cover and replace light, then put back together. Just be patient and line everything up and they snap back together no problem. High visibility sequential led lights look much better than single blink factory mirror lights. This is my third upgrade. Did blue led interior door handle lights, rear hatch led and sequential led mirror lights. Morozov has all three videos for easy install.

A product that makes the Taco into a stunner.

Easy installation. They work well and look great. The sequential turn works perfectly and matches other sequential turn signals from a different manufacturer I have my headlights from.

Easy install aging a great look!

The media could not be loaded. Excellent safety upgrade. They were also very easy to install too. Highly recommended.Installation tip : to remove the outside cover, use the included plastic pry tool at the outside of the mirror cover first and then pop off the inside. For assembly, pop in the inside first and then the outside. Also make sure to test them before reassembly to make sure they are wired correctly.

I got it as a replacment .Great product, easy to install. Highly recommend.

They do what they’re supposed to do and are very bright but I suggest an extra step installing so you don’t have to tear it apart again to fix it later.First, taking the mirror cover off takes some persuasion. I’ve done this before on my last Taco, take your time and be mindful with the pry tool, there are small flimsy wires in there that the pry tool will easily break. It’s easiest to start close to the window and work your way around with the pry tool until you can get a few fingers in there too pull it. It’s going to sound like carnage but the clips holding it on are good at their job. Just get it loose on the edges so you can grab it and then yank, it’ll come off.They give a screw driver included. Throw it out, the screws are Phillips, the screw driver I got was slotted. I thought it might be reversible, but I pulled it off and no Phillips bit on the other end.The connector they use from the light to the stock wire is very cheap and it barely holds on. It’s just a wire and a connector unlike the factory light which is just a connector molded on the actual light itself which is solid. When I plugged it in it didn’t work and I had to push it in harder, which then made it work but I found it can back out easily while still remaining clipped in. I suggest wrapping some electrical tape once it’s in on the connector to ensure it stays set and you don’t have to tear the mirror back apart to plug it back in.Also if it doesn’t work at first, flip the connector. They don’t mention this in the directions but these lights are are not reverse polarity, they will work only with the connector in one direction but the factory connector will still plug in and clip when plugged in backwards.

Love the black look. Great quality and look well. Easy install